| ANGULAR DEVIATION OF FIRST HOLE FROM TOP CENTER IN DEG | 180.0 |
| ANGULAR DEVIATION OF SECOND HOLE FROM FIRST HOLE IN DEG | 159.0 |
| ARMATURE MINIMUM SPEED IN RPM AT FULL CURRENT OUTPUT | 1950 |
| BOTTOM MOUNTING HOLE DIAMETER | 0.447 INCHES MINIMUM AND 0.459 INCHES MAXIMUM |
| DISTANCE BETWEEN INSIDE SURFACES OF HINGE BRACKET | 7.243 INCHES MINIMUM AND 7.257 INCHES MAXIMUM |
| DISTANCE BETWEEN OUTSIDE SURFACES OF HINGE BRACKET | 8.103 INCHES MINIMUM AND 8.197 INCHES MAXIMUM |
| DISTANCE BETWEEN SHAFT CENTER AND BOTTOM MOUNTING HOLE CENTER | 3.875 INCHES NOMINAL |
| DISTANCE BETWEEN SHAFT CENTER AND TOP MOUNTING HOLE CENTER | 3.500 INCHES NOMINAL |
| DISTANCE FROM END TO KEYWAY CENTER | 1.330 INCHES MINIMUM AND 1.390 INCHES MAXIMUM |
| FURNISHED ITEMS | RADIO INTERFERENCE SHIELDING AND WOODRUFF KEY |
| ENVIRONMENTAL PROTECTION | DUSTPROOF AND CORROSION RESISTANT AND FUNGUS RESISTANT |
| GROUND POLARITY TYPE | NEGATIVE |
| GROUNDING METHOD | INTERNAL |
| KEYWAY LENGTH | 0.625 INCHES NOMINAL |
| KEYWAY WIDTH | 0.125 INCHES NOMINAL |
| MAXIMUM OUTPUT CURRENT RATING IN AMPS | 18.0 |
| MAXIMUM RATED ARMATURE SPEED IN RPM | 4000 |
| MOUNTING HOLE THREAD CLASS | 2B |
| MOUNTING HOLE THREAD DIAMETER | 0.375 INCHES NOMINAL |
| MOUNTING HOLE THREAD DIRECTION | RIGHT-HAND |
| MOUNTING HOLE THREAD QUANTITY PER INCH | 16 |
| MOUNTING HOLE THREAD SERIES DESIGNATOR | UNC |
| MOUNTING STYLE | BRACKET MTD W/THREE MTG HOLES, TOP HOLE THREADED |
| NONDEFINITIVE SPEC/STD DATA | B CLASS AND 2 GRADE AND B GROUP |
| SECOND STEP DIAMETER | 0.668 INCHES MINIMUM AND 0.669 INCHES MAXIMUM |
| SHAFT DRIVE END STYLE | STRAIGHT SHAFT END, THREADED, W/KEYWAY |
| SHAFT ROTATION DIRECTION | CLOCKWISE |
| SUBMERSIBILITY | NONSUBMERSIBLE |
| TEST DATA DOCUMENT | 81349-MIL-G-12604 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| THREAD CLASS | 2A |
| THREAD DIAMETER | 0.500 INCHES NOMINAL |
| THREAD DIRECTION | RIGHT-HAND |
| THREAD LENGTH | 0.720 INCHES NOMINAL |
| THREAD SERIES | UNF |
| THREAD QUANTITY PER INCH | 20 |
| UNTHREADED PORTION LENGTH | 1.280 INCHES MINIMUM AND 1.340 INCHES MAXIMUM |
| VOLTAGE IN VOLTS | 28.0 |