| ANGULAR DEVIATION OF FIRST HOLE FROM TOP CENTER IN DEG | 15.0 |
| ANGULAR DEVIATION OF SECOND HOLE FROM FIRST HOLE IN DEG | 195.0 |
| ARMATURE MINIMUM SPEED IN RPM AT FULL CURRENT OUTPUT | 600 |
| BOTTOM MOUNTING HOLE DIAMETER | 0.627 INCHES MINIMUM AND 0.629 INCHES MAXIMUM |
| DISTANCE BETWEEN INSIDE SURFACES OF HINGE BRACKET | 6.062 INCHES NOMINAL |
| DISTANCE BETWEEN OUTSIDE SURFACES OF HINGE BRACKET | 7.250 INCHES NOMINAL |
| FURNISHED ITEMS | DRIVE PULLEY |
| ENVIRONMENTAL PROTECTION | CORROSION RESISTANT AND FUNGUS RESISTANT |
| GROUNDING METHOD | INTERNAL |
| MAXIMUM OUTPUT CURRENT RATING IN AMPS | 55.0 |
| MAXIMUM RATED ARMATURE SPEED IN RPM | 1125 |
| MINIMUM CURRENT CUT-IN SPEED IN RPM | 400 |
| MOUNTING HOLE THREAD DIAMETER | 0.438 INCHES NOMINAL |
| MOUNTING HOLE THREAD DIRECTION | RIGHT-HAND |
| MOUNTING HOLE THREAD QUANTITY PER INCH | 20 |
| MOUNTING HOLE THREAD SERIES DESIGNATOR | UNF |
| MOUNTING STYLE | BRACKET MTD W/THREE MTG HOLES, TOP HOLE THREADED |
| RECTIFIER LOCATION | SEPARATE |
| SHAFT ROTATION DIRECTION | CLOCKWISE |
| SHAFT DRIVE END STYLE | SPLINED SHAFT END, THREADED |
| SPLINE LENGTH | 2.306 INCHES MINIMUM AND 2.346 INCHES MAXIMUM |
| SPLINE MAJOR DIAMETER | 0.875 INCHES NOMINAL |
| SPLINE MINOR DIAMETER | 0.874 INCHES NOMINAL |
| SPLINE QUANTITY | 6 |
| SPLINE WIDTH | 0.217 INCHES NOMINAL |
| THREAD DIRECTION | RIGHT-HAND |
| THREAD DIAMETER | 0.625 INCHES NOMINAL |
| THREAD LENGTH | 0.688 INCHES NOMINAL |
| THREAD SERIES | UNF |
| THREAD QUANTITY PER INCH | 18 |
| VOLTAGE IN VOLTS | 24.0 |