|
|
|
National Stock Number:
3020-00-391-4050
Federal Supply Class:
3020
National Item Identification Number:
003914050
Description:
GEAR,HELICAL
Detail:
A GEAR, CYLINDRICAL IN FORM, WITH TEETH ON THE OUTER SURFACE AT AN ANGLE TO THE AXIS OF THE GEAR. SEE ALSO GEAR, ANTIBACKLASH, HELICAL:
|
Manufacturer Information:
| 3238729 | 55380 | HATCH & KIRK, INC. | | 3238729 | 72915 | GENERAL MOTORS CORP ELECTRO-MOTIVE DIV | | K-3238729 | 18954 | KORODY-COLYER CORP A CR INDUSTRIES CO | | K323879 | 18954 | KORODY-COLYER CORP A CR INDUSTRIES CO |
|
Techincal Specification:
| BODY STYLE | WEBBED, WITH LIGHTENING HOLES | | BORE NOMINAL DIAMETER | 2.0000 INCHES BOTH ENDS | | BORE STYLE | PLAIN BOTH ENDS | | FACE NOMINAL WIDTH | 1.500 INCHES | | HARDNESS RATING | 10.0 ROCKWELL C MINIMUM AND 16.0 ROCKWELL C MAXIMUM OVERALL | | HELIX ANGLE | 27.3217 DEGREES | | HUB NOMINAL DIAMETER | 2.997 INCHES FIRST END | | HUB NOMINAL DIAMETER | 2.997 INCHES SECOND END | | HUB STYLE DESIGNATOR | PLAIN BOTH ENDS | | MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-890,CLASS B MIL SPEC SINGLE MATERIAL RESPONSE OVERALL | | PITCH DIAMETER | 10.8000 INCHES NOMINAL | | MATERIAL | STEEL OVERALL | | NOMINAL DISTANCE BETWEEN BODY FACE AND PROTRUDING HUB END | 0.938 INCHES BOTH ENDS | | NOMINAL OUTSIDE DIAMETER | 11.084 INCHES | | PRESSURE ANGLE | 20.0000 DEGREES | | SPECIAL FEATURES | 2 COUNTERWEIGHTS,OIL PLUG,2 RIVETS,2 COUNTERWEIGHT HOLES 5/8 IN. DIA LOCATED 3 IN. BELOW CENTER OF BORE AND 2 IN. TO LEFT AND RIGHT OF LOWER VERTICAL CENTER LINE,FIGURE 6 STAMPED ON SIDE OF GEAR FACE ON CENTER LINE OF TOOTH SPACE 36 DEG 11 MIN CW FROM LOWER VERTICAL CENTER LINE,FIGURE 5 STAMPED ON SIDE OF GEAR FACE ON CENTER LINE OF TOOTH SPACE 73 DEG 20 MIN CW FROM FIGURE 6,FIGURE 7 STAMPED ON SIDE OF GEAR FACE ON CENTER LINE OF TOOTH SPACE 86 DEG 40 MIN CW FROM FIGURE 5,30.189 IN. DIA OIL HOLES,1 LOCATED ON HUB END 1-15/64 IN. BELOW CENTER OF BORE ON LOWER VERTICAL CENTER LINE AND DRILLED 2-13/16 IN. DEEP,2 LOCATED ON SIDE OF HUB 11/16 IN. FROM EACH HUB END AND DRILLED AT A 6 DEG ANGLE TO MEET OIL HOLE DRILLED FROM HUB | | STYLE DESIGNATOR | PROTRUDING HUBS | | TEETH QUANTITY | 54 | | TEETH TYPE | SINGLE HELIX | | TOOTH DIRECTION | LEFT | | TOOTH FORM | STUB |
|
|