|
|
|
National Stock Number:
3040-01-079-1799
Federal Supply Class:
3040
National Item Identification Number:
010791799
Description:
SHAFT,STRAIGHT
Detail:
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for jubricating holes. For items having an integral gear(s) or worm(s), see GEARSHAFT (as modified). For items designed to support rotating members see AXLE(1), STRAIGHT. For items not having the above conditions see PIN, STRAIGHT, HEADLESS. For items having machined ends which constitute steps see SHAFT(1), SHOULDERED; AXLE(1), SHOULDERED; and BOLT, FLUID PASSAGE.
|
Manufacturer Information:
| 140297 | 15434 | CUMMINS INC. | | 3801433 | 15434 | CUMMINS INC. | | MA280 21 000 | 34623 | AM GENERAL LLC |
|
Techincal Specification:
| END SIMILARITY | IDENTICAL | | FIRST END DIAMETER | 1.1230 INCHES MINIMUM AND 1.1235 INCHES MAXIMUM | | FIRST END STYLE | PLAIN | | MATERIAL | STEEL | | PROPRIETARY CHARACTERISTICS | PACS | | OVERALL LENGTH | 12.880 INCHES NOMINAL | | SPECIAL FEATURES | SEVEN HOLES,0.230 INCH DIAMETER ONO FIRST PLANE,1.310 INCH CNETER TO CENTER BETWEEN FIRST THREE HOLES,FIRST HOLE 1.790 INCH FROM FIRST END,2.030 INCH CENTER TO CENTER BETWEEN THIRD,FOURTH AND FIFTH HOLES,1.310 INCH CNETER TO CENTER BETWEEN FIFTH,SIXTH AND SEVENTH HOLES,SEVENTH HOLE IS 1.790 INCH FROM SECOND END;TWO HOLES 0.230 INCH DIAMTER 90 DEGREES FROM SECOND AND SIXTH HOLES;ONE HOLE 0.340 INCH DIAMETER LOCATED 6.750 INCH FROM END ON SECOND PLANE 90 DEGREES FROM FIRST HOLES;BORE LENGTH OF SHAFT 0.523 INCH DIAMETER,COUNTER BORE ENDS 0.630 INCH DIAMETER,0.400 INCH DEEP |
|
|