|
|
|
National Stock Number:
3040-01-138-8431
Federal Supply Class:
3040
National Item Identification Number:
011388431
Description:
SHAFT,SHOULDERED
Detail:
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (AA), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see AXLE(1), SHOULDERED. For items not having any of the above conditions see PIN, SHOULDER, HEADLESS. Excludes SHAFT(1), STRAIGHT; and AXLE(1), STRAIGHT.
|
Manufacturer Information:
| 162C9321 | 05326 | GENERAL ELECTRIC CO AVIATION COMPONENT SERVICE CENTER | | 162C9321P02 | 05326 | GENERAL ELECTRIC CO AVIATION COMPONENT SERVICE CENTER | | 162C9321P02 | 07482 | GENERAL ELECTRIC COMPANY | | 162C9321P02 | 99207 | GENERAL ELECTRIC COMPANY |
|
Techincal Specification:
| END SIMILARITY | NOT IDENTICAL | | FIRST END DIAMETER | 0.4800 INCHES NOMINAL | | FIRST END SPLINE QUANTITY | 12 | | FIRST END STYLE | SPLINED (INVOLUTE) | | FIRST END PITCH DIAMETER | 0.6000 INCHES NOMINAL | | FIRST END PRESSURE ANGLE | 30.0 DEGREES NOMINAL | | FIRST END SPLINE LENGTH | 0.7200 INCHES NOMINAL | | FIRST END SPLINE MAJOR DIAMETER | 0.6450 INCHES MINIMUM AND 0.6500 INCHES MAXIMUM | | FIRST END SPLINE MINOR DIAMETER | 0.4800 INCHES MINIMUM AND 0.4950 INCHES MAXIMUM | | LARGEST STEP DIAMETER | 0.645 INCHES MINIMUM AND 0.650 INCHES MAXIMUM | | OVERALL LENGTH | 1.200 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | AMS6260 ASSN STD SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL | | SECOND END DISTANCE FROM HOLE CENTER TO END | 0.2000 INCHES NOMINAL | | SECOND END HOLE DIAMETER | 0.1255 INCHES MINIMUM AND 0.1260 INCHES MAXIMUM | | SECOND END DIAMETER | 0.4700 INCHES MINIMUM AND 0.4705 INCHES MAXIMUM | | SECOND END STYLE | UNTHREADED CROSS DRILLED | | SPECIAL FEATURES | FIRST END 0.109 IN. CENTER DRILL 60 DEG CSK TO 0.18 IN. DIA; HEAT TREAT RC32-40; SECOND END BORE 0.351 - 0.352 IN. DIA 0.44 IN. DP 60 DEG CSK TO 0.41 IN. DIA; CROSS DRILL 4 HOLES EQUALLY SPACED; PART OF INPUT DRIVE ASSY 162C9395 | | STEP QUANTITY | 2 | | SURFACE FINISH | 63.0 MICROINCHES |
|
|