|
|
|
National Stock Number:
3040-01-475-0328
Federal Supply Class:
3040
National Item Identification Number:
014750328
Description:
SHAFT,SHOULDERED
Detail:
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (AA), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see AXLE(1), SHOULDERED. For items not having any of the above conditions see PIN, SHOULDER, HEADLESS. Excludes SHAFT(1), STRAIGHT; and AXLE(1), STRAIGHT.
|
Manufacturer Information:
| 752-7068468-23 | 53711 | NAVAL SEA SYSTEMS COMMAND | | H832-1651 | 96169 | ELECTRIC BOAT CORPORATION | | H832-1651-23A | 96169 | ELECTRIC BOAT CORPORATION |
|
Techincal Specification:
| OVERALL LENGTH | 2.760 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | ASTM-A564 FED SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL | | PART NAME ASSIGNED BY CONTROLLING AGENCY | QUILL SHAFT | | SPECIAL FEATURES | MATERIAL IS STAINLESS STEEL; THIS PART OF WEAPONS HANDLING ATHWARTSHIP DRIVE GEARBOX SUB ASSEMBLY; PROTECT THIS SURFACE PRIOR TO ASSEMBLY; ANGULAR RELATIONSHIP OF SPLINE 1 TEETH MAY VARY FREELY, AS A UNIT, TO SPLINE 2 TEETH; REMOVE ALL BURRS AND SHARP EDGES, AND WHERE MACHINED CORNER OR FILLET RADII ARE NOT DIMENSIONED. .015 MAXIMUM REDIUS SHALL BE USED | | STEP QUANTITY | 1 |
|
|