| MATERIAL | STEEL COMP 440C BALL |
| STEEL COMP 440C INNER RING |
| STEEL COMP 440C OUTER RING |
| PLASTIC AND |
| PLASTIC PHENOLIC RETAINER |
| MATERIAL DOCUMENT AND CLASSIFICATION | AISI ASSN STD SINGLE MATERIAL RESPONSE BALL |
| AISI ASSN STD SINGLE MATERIAL RESPONSE INNER RING |
| AISI ASSN STD SINGLE MATERIAL RESPONSE OUTER RING |
| MIL-P-79,FORM T,TYPE FBE MIL SPEC SINGLE MATERIAL RESPONSE RETAINER |
| SURFACE TREATMENT | PASSIVATE BALL |
| PASSIVATE INNER RING |
| PASSIVATE OUTER RING |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE BALL |
| QQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE INNER RING |
| QQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE OUTER RING |
| STYLE DESIGNATOR | COUNTERBORED OUTER RINGS, NON-SEPARABLE, BACK TO BACK MOUNTING |
| OVERALL WIDTH | 0.4850 INCHES MINIMUM AND |
| 0.4900 INCHES MAXIMUM |
| BORE DIAMETER | 10.9992 INCHES MINIMUM AND |
| 11.0000 INCHES MAXIMUM |
| OVERALL OUTSIDE DIAMETER | 11.4992 INCHES MINIMUM AND |
| 11.5000 INCHES MAXIMUM |
| LUBRICATION MATERIAL | OIL |
| LUBRICATION MATERIAL DOCUMENT AND CLASSIFICATION | MIL-L-6085 MIL SPEC SINGLE MATERIAL RESPONSE |
| STANDARD TOLERANCE DESIGNATION | ABEC NO.3 |
| SURFACE FINISH | GROUND |
| RETAINER FABRICATION METHOD | MACHINED |
| LOAD DIRECTION | ANGULAR |
| INTERNAL FIT-UP DESIGNATION | STANDARD |
| BEARING PRELOAD RATING | 180.0 POUNDS MINIMUM AND |
| 260.0 POUNDS MAXIMUM |
| CONTACT ANGLE | 30.0 DEGREES NOMINAL |
| SPECIAL FEATURES | 24 DROPS OF SPECIFIED LUBRICANT FROM A NO. 26 HYPODERMIC NEEDLE |