| MATERIAL | STEEL END PLATE |
| STEEL COMP E52100 OUTER RING |
| STEEL COMP E52100 ROLLER |
| PLASTIC ACETAL OR |
| PLASTIC POLYAMIDE SEAL |
| STEEL COMP E52100 STUD |
| MATERIAL DOCUMENT AND CLASSIFICATION | SAE ASSN STD SINGLE MATERIAL RESPONSE OUTER RING |
| SAE ASSN STD SINGLE MATERIAL RESPONSE ROLLER |
| SAE ASSN STD SINGLE MATERIAL RESPONSE STUD |
| SURFACE TREATMENT | CADMIUM EXPOSED SURFACES OF STUD AND WASHER AS MOUNTED |
| CHROMIUM OUTER RING |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TYPE 1,CLASS 2 FED SPEC SINGLE TREATMENT RESPONSE EXPOSED SURFACES OF STUD AND WASHER AS MOUNTED |
| QQ-C-320 FED SPEC SINGLE TREATMENT RESPONSE OUTER RING |
| STYLE DESIGNATOR | CAM FOLLOWER |
| THREAD LENGTH | 0.4220 INCHES NOMINAL |
| OVERALL LENGTH | 1.5215 INCHES NOMINAL |
| OVERALL OUTSIDE DIAMETER | 1.0000 INCHES NOMINAL |
| STUD DIAMETER | 0.4370 INCHES NOMINAL |
| OUTER RING WIDTH | 0.5310 INCHES NOMINAL |
| STUD LENGTH | 0.9845 INCHES NOMINAL |
| THREAD SERIES DESIGNATOR | UNJF |
| NOMINAL THREAD SIZE | 0.4375 INCHES |
| THREAD QUANTITY PER INCH | 20 |
| THREAD CLASS | 3A |
| THREAD DIRECTION | RIGHT-HAND |
| LUBRICATION MATERIAL DOCUMENT AND CLASSIFICATION | MIL-G-81322 MIL SPEC SINGLE MATERIAL RESPONSE |
| STANDARD TOLERANCE DESIGNATION | AFBMA STD TOLERANCE FOR CAN FOLLWER NEEDLE BEARING |
| SEAL QUANTITY | 2 |
| BEARING SEAL TYPE | CONTACT |
| ALIGNMENT TYPE | RIGID |
| INTERNAL FIT-UP DESIGNATION | STANDARD |
| FEATURES PROVIDED | FLUSH LUBRICATION FITTING |
| TEST DATA DOCUMENT | 81349-MIL-I-6868 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| LUBRICATION MATERIAL | GREASE |
| SPECIAL FEATURES | END PLATE HARDENED TORC 51.0 MIN TO RC 59.0 MAX,RACEWAY HEAT TREATED TO RC 60.0 MIN,CORE AND STUDLG HEAT TREATED TO RC 36.0 MIN TO RC 44.0 MAX; LUBRICATOR IN FLANGED END OF STUD |
| SPECIFICATION/STANDARD DATA | 80205-NAS562 PROFESSIONAL/INDUSTRIAL ASSOCIATION STANDARD |