| CONNECTION TYPE | THREADED INTERNAL TUBE 1ST END |
| MEDIA FOR WHICH DESIGNED | FUEL/OIL, HYDROCARBON SINGLE RESPONSE |
| MEASURING METHOD AND LENGTH | 24.000 INCHES NOMINAL OVERALL |
| CROSS-SECTIONAL SHAPE STYLE | ROUND |
| TEMP RATING | -40.0 DEG FAHRENHEIT AND |
| 200.0 DEG FAHRENHEIT SINGLE RESPONSE |
| MAXIMUM OPERATING PRESSURE | 3800.0 POUNDS PER SQUARE INCH |
| HYDROSTATIC TEST PRESSURE | 7000.0 POUNDS PER SQUARE INCH |
| BURST TEST PRESSURE | 16000.0 POUNDS PER SQUARE INCH |
| EXTERIOR COLOR | BLACK |
| OUTER COVERING ENVIRONMENTAL PROTECTION | ABRASION RESISTANT AND |
| OIL RESISTANT AND |
| WATER RESISTANT |
| LAYER COMPOSITION AND LOCATION | 1ST LAYER BRAIDED STEEL WIRE AND |
| 2ND LAYER BRAIDED STEEL WIRE AND |
| 3RD LAYER BRAIDED STEEL WIRE AND |
| 4TH LAYER BRAIDED STEEL WIRE AND |
| OUTER LAYER MOLDED RUBBER, SYNTHETIC |
| MINIMUM INSIDE BENDING RADIUS | 12.000 INCHES |
| INSIDE DIAMETER | 1.000 INCHES NOMINAL |
| OUTSIDE DIAMETER | 1.547 INCHES NOMINAL |
| INSIDE SURFACE CONDITION | SMOOTH |
| END FITTING COMPONENT AND MATERIAL | COMPLETE FITTING STEEL ALL ENDS |
| FITTING COMPONENT AND SURFACE TREATMENT | COMPLETE FITTING CADMIUM AND |
| COMPLETE FITTING ZINC 1ST END |
| CONNECTION STYLE | SWIVEL NUT FLARE 1ST END |
| SEAT ANGLE | 37.0 DEGREES 1ST END |
| END CONNECTION DESIGN | STRAIGHT 1ST END |
| THREAD SERIES DESIGNATOR | UN 1ST END |
| NOMINAL THREAD SIZE | 1.312 INCHES 1ST END |
| THREAD QUANTITY PER INCH | 12 1ST END |
| THREAD CLASS | 2B 1ST END |
| THREAD DIRECTION | RIGHT-HAND 1ST END |
| FEATURES PROVIDED | ELECTROSTATIC DISCHARGE CAPABILITY |
| TEST DATA DOCUMENT | 81349-MIL-L-52325,PARAGRAPH 4.7.2.1 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| SPECIAL FEATURES | INNER CONVEYING TUBE MATERIAL-RUBBER, SYNTHETIC; ALUMINUM IDENTIFICATION SLEEVE ON HOSE,MIL-L-52325,PARAGRAPH 3.9.1 |