| END CONNECTION DESIGN | ELBOW 1ST END |
| END CONNECTION DESIGN | ELBOW 2ND END |
| ANGLE BETWEEN RIGID ELBOW FITTINGS IN DEG | 180.0 |
| BURST TEST PRESSURE | 3500.0 POUNDS PER SQUARE INCH |
| CONNECTION TYPE | THREADED INTERNAL TUBE 1ST END |
| CONNECTION TYPE | THREADED INTERNAL TUBE 2ND END |
| CONNECTION STYLE | SWIVEL NUT FLARE 1ST END |
| CONNECTION STYLE | SWIVEL NUT FLARE 2ND END |
| CROSS-SECTIONAL SHAPE STYLE | ROUND |
| FEATURES PROVIDED | ELECTROSTATIC DISCHARGE CAPABILITY |
| FLOW ANGLE | 74.5 DEGREES 1ST END |
| FLOW ANGLE | 90.0 DEGREES 2ND END |
| HYDROSTATIC TEST PRESSURE | 2500.0 POUNDS PER SQUARE INCH |
| INSIDE DIAMETER | 0.875 INCHES NOMINAL |
| INSIDE SURFACE CONDITION | SMOOTH |
| LAYER COMPOSITION AND LOCATION | 1ST LAYER BRAIDED CORROSION RESISTANT STEEL WIRE AND OUTER LAYER BRAIDED CORROSION RESISTANT STEEL WIRE |
| OUTSIDE DIAMETER | 1.109 INCHES NOMINAL |
| MAXIMUM OPERATING PRESSURE | 1250.0 POUNDS PER SQUARE INCH |
| MEDIA FOR WHICH DESIGNED | AIR AND FUEL/OIL, HYDROCARBON AND HYDRAULIC FLUID SINGLE RESPONSE |
| MEASURING METHOD AND LENGTH | 9.210 INCHES NOMINAL EXCLUDING END FITTINGS |
| MINIMUM INSIDE BENDING RADIUS | 7.375 INCHES |
| NOMINAL THREAD SIZE | 1.312 INCHES 1ST END |
| NOMINAL THREAD SIZE | 1.312 INCHES 2ND END |
| OUTER COVERING ENVIRONMENTAL PROTECTION | CORROSION RESISTANT |
| SPECIAL FEATURES | 1ST END ELBOW TUBE HAS HOLE DRILLED AND MACHINED TO ACCOMODATE 1/4 IN. TUBE BOSS CONNECTION |
| SEAT ANGLE | 37.0 DEGREES 1ST END |
| SEAT ANGLE | 37.0 DEGREES 2ND END |
| TEMP RATING | -65.0 FAHRENHEIT AND 275.0 FAHRENHEIT SINGLE RESPONSE |
| TEST DATA DOCUMENT | 89372-HE271-5005 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
| THREAD DIRECTION | RIGHT-HAND 1ST END |
| THREAD DIRECTION | RIGHT-HAND 2ND END |
| THREAD CLASS | 3B 2ND END |
| THREAD CLASS | 3B 1ST END |
| THREAD SERIES DESIGNATOR | UNJ 1ST END |
| THREAD SERIES DESIGNATOR | UNJ 2ND END |
| THREAD QUANTITY PER INCH | 12 1ST END |
| THREAD QUANTITY PER INCH | 12 2ND END |
| VACUUM IN TORR | 406.4 |