| END CONNECTION DESIGN | ELBOW 2ND END |
| END CONNECTION DESIGN | STRAIGHT 1ST END |
| BURST TEST PRESSURE | 17000.0 POUNDS PER SQUARE INCH |
| CONNECTION TYPE | THREADED INTERNAL TUBE 1ST END |
| CONNECTION STYLE | SWIVEL NUT, GASKET SEAL 1ST END |
| CROSS-SECTIONAL SHAPE STYLE | ROUND |
| FLOW ANGLE | 90.0 DEGREES 2ND END |
| PART NAME ASSIGNED BY CONTROLLING AGENCY | HOSE ASSEMBLY, NONMETALLIC |
| PROPRIETARY CHARACTERISTICS | PACS |
| MAXIMUM OPERATING PRESSURE | 4250.0 POUNDS PER SQUARE INCH |
| MEASURING METHOD AND LENGTH | 68.000 INCHES NOMINAL OVERALL |
| MINIMUM INSIDE BENDING RADIUS | 7.000 INCHES |
| NOMINAL INSIDE DIAMETER HOSE ACCOMMODATED | 0.500 INCHES 1ST END |
| NOMINAL THREAD SIZE | 0.8125 INCHES 1ST END |
| OUTSIDE DIAMETER | 0.880 INCHES MAXIMUM |
| SPECIAL FEATURES | CONSTRUCTION: SYNTHETIC RUBBER TUBE; TWO BRAIDS OF SPECIAL HIGH TENSILE STEEL WIRE REINFORCEMENT; MSHA ACCEPTED SYNTHETIC RUBBER COVER. APPLICATION AND TEMPERATURE RANGE: HIGH PRESSURE SERVICE HOSE FOR USE WITH: PETROLEUM-AND POLYESTER-BASED HYDRAULIC FLUIDS AND LUBRICATING OILS WITHIN A TEMPERATURE RANGE OF -40 DEGREES F TO +212 DEGREES F CONTINUOUS AND +257 DEGREES F INTERMITTENT: WATER, WATER/GLYCOL, AND WATER/OIL EMULSION HYDRAULIC FLUIDS UP TO +185 DEGREE F: AIR WITHIN A TEMPERATURE RANGE OF -40 DEGREES F TO +158 DEGREES F. FOR AIR PRESSURE ABOVE 250 PSI THE COVER SHOULD BE PIN PRICKED. |
| TEMP RATING | -40.0 DEG FAHRENHEIT SINGLE RESPONSE AND 212.0 DEG FAHRENHEIT SINGLE RESPONSE |
| THREAD DIRECTION | RIGHT-HAND 1ST END |
| THREAD QUANTITY PER INCH | 16 1ST END |
| THREAD SERIES DESIGNATOR | UN 1ST END |