|
|
|
National Stock Number:
5310-01-144-3124
Federal Supply Class:
5310
National Item Identification Number:
011443124
Description:
WASHER,FLAT
Detail:
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
|
Manufacturer Information:
| 117185-1 | 94271 | LOCKHEED MARTIN CORP | | 512-22-172 | 07421 | L3HARRIS INTERSTATE ELECTRONICS CORPORATION |
|
Techincal Specification:
| CENTER HOLE SHAPE STYLE | ROUND | | CRITICALITY CODE JUSTIFICATION | ZZZY | | CROSS-SECTIONAL SHAPE STYLE | RECTANGULAR | | HOLE DIAMETER | 0.125 INCHES NOMINAL | | MATERIAL | RUBBER SILICONE CLASS Q OVERALL | | PERIPHERAL SHAPE STYLE | ROUND | | PROPRIETARY CHARACTERISTICS | PACS | | OVERALL DIAMETER | 0.312 INCHES NOMINAL | | REFERENCE NUMBER DIFFERENTIATING CHARACTERISTICS | AS DIFFERENTIATED BY MATERIAL WHICH MUST CONFORM TO SHIPS PARTS CONTROL CENTER SPECIAL QUALITY CONTROL PROVISIONS AND CERTIFIED FREE FROM MERCURY CONTAMINATION | | SPECIAL TEST FEATURES | SPECIAL QUALITY CONTROL TESTING | | TEST DATA DOCUMENT | 81349-MIL-P-23199 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). | | THICKNESS | 0.062 INCHES NOMINAL |
|
|