|
|
|
National Stock Number:
5315-01-054-6049
Federal Supply Class:
5315
National Item Identification Number:
010546049
Description:
PIN,SHOULDER,HEADLESS
Detail:
A cylindrically-shaped headless item, having a shank at one or both ends. It is used for aligning, fastening, or transfer of torque and/or thrust by fitting into corresponding holes of another item. It may be threaded on one end.
|
Manufacturer Information:
| 196B7404 | 05606 | GENERAL DYNAMICS-OTS, INC. |
|
Techincal Specification:
| CENTER TO CENTER DISTANCE BETWEEN HOLES | 0.320 INCHES NOMINAL | | DISTANCE FROM CENTERLINE OF HOLE TO END OF PIN | 0.450 INCHES NOMINAL | | FIRST END TAPER ANGLE | 146.0 DEGREES NOMINAL | | FIRST END LOCATION | SHANK END | | FIRST HOLE DIAMETER | 0.066 INCHES NOMINAL | | HARDNESS RATING | 30.0 ROCKWELL C MINIMUM AND 35.0 ROCKWELL C MAXIMUM OVERALL | | HOLE ARRANGEMENT STYLE | BOTH END DRILLED | | OVERALL LENGTH | 2.550 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | AMS 6395 ASSN STD SINGLE MATERIAL RESPONSE OVERALL | | MATERIAL | STEEL OVERALL | | SECOND HOLE DIAMETER | 0.064 INCHES NOMINAL | | SHANK DIAMETER | 0.190 INCHES NOMINAL | | SHANK LENGTH | 1.490 INCHES NOMINAL | | STYLE DESIGNATOR | SHOULDER | | SPECIAL FEATURES | SHOULDER IS 0.440 IN. LG,0.245 IN. WD,WITH FLAT CUT 0.350 IN. LG,0.161 IN. DP AT SHAFT END,SHAFT IS CENTERED ALONG WIDTH,0.174 IN. FROM SHOULDER END OPPOSITE FLAT,SHOULDER IS CHAMFERED 0.040 X 45 DEG TWO PLACES ENTIRE1.060 IN. LG | | SURFACE FINISH | 125.000 MICROINCHES OVERALL | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | MIL-STD-171 MIL STD SINGLE TREATMENT RESPONSE OVERALL | | SURFACE TREATMENT | OXIDE FILM OVERALL |
|
|