| FIRST END STYLE | CHAMFERED |
| HEAD STYLE | FLAT COUNTERSUNK UNDERCUT |
| MATERIAL | STEEL COMP 1045 OVERALL |
| STYLE DESIGNATOR | GROOVE |
| MATERIAL DOCUMENT AND CLASSIFICATION | 1E361,FSCM 11083 MFR REF SINGLE MATERIAL RESPONSE OVERALL |
| HARDNESS RATING | 58.0 ROCKWELL C MINIMUM SHANK |
| DIAMETER | 76.51 MILLIMETERS MINIMUM AND |
| 76.63 MILLIMETERS MAXIMUM |
| EFFECTIVE LENGTH | 44.0 MILLIMETERS NOMINAL |
| UNDERCUT DIAMETER | 72.57 MILLIMETERS NOMINAL |
| UNDER HEAD LENGTH | 151.0 MILLIMETERS NOMINAL |
| UNDERCUT RADIUS | 12.0 MILLIMETERS MINIMUM AND |
| 14.0 MILLIMETERS MAXIMUM |
| GRIP LENGTH | 57.0 MILLIMETERS NOMINAL |
| FIRST END TAPER ANGLE | 20.0 DEGREES NOMINAL |
| PIN HEAD DIAMETER | 89.05 MILLIMETERS MINIMUM AND |
| 89.55 MILLIMETERS MAXIMUM |
| HEIGHT | 32.0 MILLIMETERS MINIMUM AND |
| 34.0 MILLIMETERS MAXIMUM |
| HOLE ARRANGEMENT STYLE | ONE END DRILLED |
| FIRST HOLE DIAMETER | 6.0 MILLIMETERS NOMINAL |
| DISTANCE FROM CENTERLINE OF HOLE TO END OF PIN | 94.0 MILLIMETERS NOMINAL |
| SURFACE FINISH | 1.6 MICRONS HEAD OUTSIDE DIAMETER |
| 0.80 MICRONS SHANK END |
| SPECIAL FEATURES | 6.0 MM DIA HOLE ON SHAFT IS 21.0 MM MIN AND 24.0 MM MAX DEEP;TWO HOLES ON HEAD BEARING SURFACE ARE 11.0 MM DIA AND 32.0 MM DEEP AND ARE TAPPED 0.500 IN. 13-2B UNC; ONE HOLE ON HEAD BEARING SURFACE IS 8.5 MM MIN DIA AND 9.1 MM MAX DIA AND 95.0 MM DEEP AND TAPPED 0.125 IN. 27-2B NPSF |
| THE MANUFACTURERS DATA | |
| MANUFACTURERS CODE | 11083 |
| DESIGN CONTROL REFERENCE | 1243240 |