5365-01-083-2881, SPACER,PLATE

National Stock Number:
5365-01-083-2881

Federal Supply Class:
5365

National Item Identification Number:
010832881

Description:
SPACER,PLATE

Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.

Manufacturer Information:

696641-4

99193

HONEYWELL INTERNATIONAL INC.

Techincal Specification:

APERTURE DIAMETER	0.295 INCHES MINIMUM AND 0.300 INCHES MAXIMUM
BOLT CIRCLE DIAMETER	1.700 INCHES NOMINAL
LARGEST BOLT HOLE DIAMETER	0.170 INCHES MINIMUM AND 0.190 INCHES MAXIMUM
LARGEST BOLT HOLE QUANTITY	3
OUTSIDE CORNER INVERTED RADIUS	0.230 INCHES MINIMUM AND 0.290 INCHES MAXIMUM
OUTSIDE CORNER RADIUS	0.180 INCHES MINIMUM AND 0.210 INCHES MAXIMUM
OVERALL WIDTH	1.910 INCHES NOMINAL
MATERIAL DOCUMENT AND CLASSIFICATION	QQ-A-250/4,T4 FED SPEC SINGLE MATERIAL RESPONSE OR QQ-A-250/11,T6 FED SPEC SINGLE MATERIAL RESPONSE
MATERIAL	ALUMINUM ALLOY 2024 OR ALUMINUM ALLOY 6061
SPECIAL FEATURES	3 LARGER BOLT HOLES ALONG O.D.,3 SMALLER BOLT HOLES ALONG I.D.
SIDE RADIUS FROM GASKET CENTER	0.720 INCHES MINIMUM AND 0.750 INCHES MAXIMUM
SMALLEST BOLT HOLE DIAMETER	0.110 INCHES MINIMUM AND 0.130 INCHES MAXIMUM
SMALLEST BOLT HOLE QUANTITY	3
SURFACE TREATMENT DOCUMENT AND CLASSIFICATION	EMS 52401,TYPE 1,CLASS A MFR REF SINGLE TREATMENT RESPONSE
SURFACE TREATMENT	ANODIZE

Click here to Register for Free 30-day Trial