|
|
|
National Stock Number:
5365-01-228-4781
Federal Supply Class:
5365
National Item Identification Number:
012284781
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 205-030-035-5 | 97499 | BELL TEXTRON INC |
|
Techincal Specification:
| BOLT HOLE QUANTITY | 4 | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 0.750 INCHES NOMINAL | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG WIDTH | 0.625 INCHES NOMINAL | | HOLE DIAMETER | 0.190 INCHES MINIMUM AND 0.196 INCHES MAXIMUM | | MATERIAL DOCUMENT AND CLASSIFICATION | MIL-P-15035,TY FB6 MIL SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | PLASTIC PHENOLIC | | PROPRIETARY CHARACTERISTICS | NPAC | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG WIDTH | 0.625 INCHES MINIMUM | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.328 INCHES NOMINAL | | OVERALL LENGTH | 2.000 INCHES NOMINAL | | OVERALL WIDTH | 1.500 INCHES NOMINAL | | SPECIAL FEATURES | HOLES COUNTERSUNK 0.390 IN. DIA BY 100 DEG |
|
|