|
|
|
National Stock Number:
5365-01-230-0002
Federal Supply Class:
5365
National Item Identification Number:
012300002
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 0002-4018-201 | 06032 | ANTENNA PRODUCTS CORPORATION |
|
Techincal Specification:
| OVERALL LENGTH | 20.750 INCHES MINIMUM AND 21.000 INCHES MAXIMUM | | OVERALL WIDTH | 2.000 INCHES NOMINAL | | SPECIAL FEATURES | HAS 2 HOLES 0.344 IN. DIA 1.312 IN. FROM EDGE ALONG LENGTH AND 1.000 IN. FROM CENTER OF HOLE TO EDGE ALONG WIDTH; 2 HOLES 0.375 IN. DIA 2.312 IN. C TO C DISTANCE BETWEEN HOLES CENTER OF 1ST HOLE TO EDGE LEFT SIDE 9.281 IN. ALSO 1.000 IN. FROM CENTER OF HOLE TO-EDGE ALONG WIDTH | | STYLE DESIGNATOR | RECTANGULAR |
|
|