|
|
|
National Stock Number:
5365-01-257-9179
Federal Supply Class:
5365
National Item Identification Number:
012579179
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 60022180G02 | 58307 | GENERAL ATOMICS ELECTRONIC SYSTEMS, INC. DIV N/A | | 60022180GP2 | 58307 | GENERAL ATOMICS ELECTRONIC SYSTEMS, INC. DIV N/A | | RO0113 | 13573 | PARKER HANNIFIN CORP |
|
Techincal Specification:
| BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE | 0.180 INCHES NOMINAL | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 0.625 INCHES NOMINAL | | CRITICALITY CODE JUSTIFICATION | ZZZY | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.200 INCHES NOMINAL | | OVERALL LENGTH | 1.650 INCHES NOMINAL | | OVERALL WIDTH | 0.400 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | QQ-S-766 FED SPEC ALL MATERIAL RESPONSES | | MATERIAL | STEEL COMP 302 OR STEEL COMP 304 | | REFERENCE NUMBER DIFFERENTIATING CHARACTERISTICS | AS DIFFERENTIATED BY MATERIAL WHICH MUST CONFORM TO SHIPS PARTS CONTROL CENTER SPECIAL QUALITY CONTROL PROVISIONS | | SPECIAL FEATURES | TWO HOLES 0.194 IN. DIA,COUNTERSINK 100 DEGREES,ONE HOLE CENTER 0.169 IN. DIA,COUNTERSINK 100 DEGREES | | SPECIAL TEST FEATURES | SPECIAL QUALITY CONTROL TESTING | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-35,TYPE 2 FED SPEC SINGLE TREATMENT RESPONSE | | SURFACE TREATMENT | PASSIVATE | | TEST DATA DOCUMENT | 81349-MIL-P-23199 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
|
|