|
|
|
National Stock Number:
5365-01-293-1409
Federal Supply Class:
5365
National Item Identification Number:
012931409
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 68B33256 | 98747 | OGDEN AIR LOGISTICS CENTER |
|
Techincal Specification:
| APERTURE DIAMETER | 1.000 INCHES NOMINAL | | BOLT CIRCLE DIAMETER | 1.875 INCHES NOMINAL | | BOLT HOLE QUANTITY | 3 | | HOLE DIAMETER | 0.209 INCHES MINIMUM AND 0.211 INCHES MAXIMUM | | OUTSIDE DIAMETER | 2.250 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | QQ-S-698 COND CRCQ 1015-1020 FED SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL | | SPECIAL FEATURES | TWO HOLES EQUALLY SPACED THIRD HOLE 30 DEGREES BELOW HOLE ON RIGHT SIDE; ITEM HAS 63 MICROINCH FINISH |
|
|