|
|
|
National Stock Number:
5905-01-156-8545
Federal Supply Class:
5905
National Item Identification Number:
011568545
Description:
RESISTOR,FIXED,FILM
Detail:
A resistor whose ohmic value cannot be adjusted or varied. The resistance element consists of either a thin layer of conductive material, containing either binders or insulating materials, deposited on an insulated form; or an alloy of metal and ceramic materials, usually fused to an insulated form. Opposition to the flow of current is an inherent property of the materials used and is manifest by the heat dissipation in the resistor. See also ATTENUATOR, FIXED and RESISTOR, FIXED, COMPOSITION. Excludes carbon composition type resistors.
|
Manufacturer Information:
| 582R115H03 | 97942 | NORTHROP GRUMMAN SYSTEMS CORPORATION | | MG780-1506F | 19647 | CADDOCK ELECTRONICS INC. | | MOX-3-121506FT | 63060 | HEICO OHMITE LLC DBA OHMITE MFG CO INC | | MOX-3-1506F | 63060 | HEICO OHMITE LLC DBA OHMITE MFG CO INC | | ROX-3-1506F | 91637 | VISHAY DALE ELECTRONICS, LLC |
|
Techincal Specification:
| ELECTRICAL RESISTANCE | 150.000 MEGOHMS | | AMBIENT TEMP AT FULL RATED POWER | 70.0 CELSIUS | | AMBIENT TEMP IN DEG CELSIUS AT ZERO PERCENT RATED POWER | 220.0 | | BODY DIAMETER | 0.285 INCHES MINIMUM AND 0.345 INCHES MAXIMUM | | BODY LENGTH | 3.065 INCHES MINIMUM AND 3.185 INCHES MAXIMUM | | INCLOSURE TYPE | ENCAPSULATED | | POWER DISSIPATION RATING IN WATTS | 7.500 FREE AIR | | PRECIOUS MATERIAL AND LOCATION | TERMINAL SURFACES GOLD | | RELIABILITY FAILURE RATE LEVEL IN PERCENT | 0.001 | | RELIABILITY INDICATOR | ESTABLISHED | | RESISTANCE TOLERANCE IN PERCENT | -1.000 TO 1.000 | | STYLE DESIGNATOR | AXIAL TERMINAL EACH END | | TEMP COEFFICIENT OF RESISTANCE IN PPM PER DEG CELSIUS | -500.0 TO 500.0 | | TEMP RANGE OF TEMP COEFFICIENT IN DEG CELSIUS | -55.0 TO 125.0 | | TERMINAL LENGTH | 1.300 INCHES MAXIMUM | | TERMINAL TYPE | WIRE LEAD | | TEST DATA DOCUMENT | 97942-582R115 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
|
|