| DISSIPATION FACTOR AT REFERENCE TEMP IN PERCENT | 0.1500 |
| BODY HEIGHT | 0.020 INCHES MINIMUM AND 0.055 INCHES MAXIMUM |
| BODY LENGTH | 0.080 INCHES NOMINAL |
| BODY STYLE | CHIP TYPE |
| BODY WIDTH | 0.050 INCHES NOMINAL |
| CAPACITANCE VALUE PER SECTION | 220.000 PICOFARADS SINGLE SECTION |
| CASE MATERIAL | CERAMIC |
| INSULATION RESISTANCE AT REFERENCE TEMP | 100000.0 MEGOHMS |
| PROPRIETARY CHARACTERISTICS | PACS |
| NONDERATED CONTINUOUS VOLTAGE RATING AND TYPE PER SECTION | 100.0 DC SINGLE SECTION |
| NONDERATED OPERATING TEMP | -55.0 DEG CELSIUS MINIMUM AND 125.0 DEG CELSIUS MAXIMUM |
| RELIABILITY FAILURE RATE LEVEL IN PERCENT | 0.001 |
| RELIABILITY INDICATOR | ESTABLISHED |
| SCHEMATIC DIAGRAM DESIGNATOR | NO COMMON OR GROUNDED ELECTRODE(S) |
| SPECIFICATION/STANDARD DATA | 81349-MIL-C-123 GOVERNMENT SPECIFICATION AND 81349-MIL-C-55681 GOVERNMENT SPECIFICATION |
| SPECIAL FEATURES | SELECTED ITEM |
| TERMINAL LENGTH | 0.010 INCHES NOMINAL |
| TERMINAL TYPE AND QUANTITY | 2 BONDING PAD |
| TERMINAL SURFACE TREATMENT | SOLDER |
| TEST DATA DOCUMENT | 81349-MIL-C-123 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). AND 81349-MIL-C-55681 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). AND 98230-0N365338 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
| TOLERANCE RANGE PER SECTION | -5.00/+5.00 PERCENT SINGLE SECTION |