| BODY HEIGHT | 0.300 INCHES MAXIMUM |
| BODY LENGTH | 1.000 INCHES MAXIMUM |
| BODY STYLE | SINGLE INLINE |
| BODY WIDTH | 0.135 INCHES MAXIMUM |
| CAPACITANCE VALUE PER SECTION | 390.000 PICOFARADS ALL SECTIONS |
| CENTER TO CENTER DISTANCE BETWEEN TERMINALS PARALLEL TO LENGTH | 0.890 INCHES MINIMUM AND 0.910 INCHES MAXIMUM |
| DISSIPATION FACTOR AT REFERENCE TEMP IN PERCENT | 0.100 |
| INSULATION RESISTANCE AT REFERENCE TEMP | 100000.0 MEGOHMS |
| MATERIAL | PLASTIC CASE |
| NONDERATED CONTINUOUS VOLTAGE RATING AND TYPE PER SECTION | 100.0 DC ALL SECTIONS |
| NONDERATED OPERATING TEMP | -55.0 CELSIUS MINIMUM AND 125.0 CELSIUS MAXIMUM |
| POWER FACTOR AT REFERENCE TEMP IN PERCENT | 1000.000 |
| RELIABILITY INDICATOR | NOT ESTABLISHED |
| SCHEMATIC DIAGRAM DESIGNATOR | SERIES CONNECTED, END TERMINAL GROUNDED TO CASE |
| SECTION QUANTITY | 8 |
| TEMP COEFFICIENT OF CAPACITANCE PER SECTION IN PPM PER DEG CELSIUS | 0.0 ALL SECTIONS |
| TERMINAL DIAMETER | 0.016 INCHES MINIMUM AND 0.020 INCHES MAXIMUM |
| TERMINAL LENGTH | 0.115 INCHES MINIMUM |
| TERMINAL SURFACE TREATMENT | SOLDER |
| TERMINAL TYPE AND QUANTITY | 10 PIN |
| TEST DATA DOCUMENT | 14933-87120-39 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
| TOLERANCE OF TEMP COEFFICIENT PER SECTION IN PPM PER DEG CELSIUS | -30.0 TO 30.0 ALL SECTIONS |
| TOLERANCE RANGE PER SECTION | -5.00 TO 5.00 PERCENT ALL SECTIONS |