| CONTACT LOAD CURRENT RATING | 50.0 MILLIAMPERES RESISTIVE LOAD AC AT SEA LEVEL |
| CONTACT LOAD CURRENT RATING | 500.0 MILLIAMPERES RESISTIVE LOAD DC AT SEA LEVEL |
| CONTACT SWITCHING ACTION | BREAKS BEFORE MAKES SINGLE SECTION REAR |
| CONTACT VOLTAGE RATING IN VOLTS | 30.0 DC AT SEA LEVEL |
| CONTACT VOLTAGE RATING IN VOLTS | 300.0 AC AT SEA LEVEL |
| INDIVIDUAL SECTION QUANTITY | 1 |
| LONGEST HORIZONTAL DISTANCE BETWEEN MOUNTING CENTERS | 1.370 INCHES MINIMUM AND 1.380 INCHES MAXIMUM SINGLE MOUNTING FACILITY |
| OVERALL HEIGHT | 1.734 INCHES MINIMUM AND 1.766 INCHES MAXIMUM |
| OVERALL LENGTH | 1.907 INCHES MINIMUM AND 1.937 INCHES MAXIMUM |
| OVERALL WIDTH | 1.734 INCHES MINIMUM AND 1.766 INCHES MAXIMUM |
| MOUNTING FACILITY PATTERN | TWO POSITION IN-LINE SINGLE MOUNTING FACILITY |
| MOUNTING METHOD | THREADED BUSHING 1ST MOUNTING FACILITY |
| MOUNTING METHOD | THREADED HOLE 2ND MOUNTING FACILITY |
| NOMINAL THREAD SIZE | 0.138 INCHES 2ND MOUNTING FACILITY |
| NOMINAL THREAD SIZE | 0.375 INCHES 1ST MOUNTING FACILITY |
| NONTURN DEVICE RADIUS | 0.490 INCHES MINIMUM AND 0.510 INCHES MAXIMUM AT 12:00 O'CLOCK |
| NONTURN DEVICE TYPE | TAB AT 12:00 O'CLOCK |
| OPERATING TEMP RANGE | -65.0 TO 125.0 CELSIUS |
| POLE QUANTITY | 2 SINGLE SECTION REAR |
| SHAFT DIAMETER | 0.249 INCHES MINIMUM AND 0.251 INCHES MAXIMUM SINGLE ACTUATOR |
| SHAFT LENGTH | 0.750 INCHES NOMINAL SINGLE ACTUATOR |
| SHAFT TYPE | ROUND SINGLE ACTUATOR |
| STYLE DESIGNATOR | TAP, SQUARE FRAME |
| SWITCH ACTUATOR INDEXING POSITION QUANTITY | 6 SINGLE ACTUATOR |
| SWITCH ACTUATOR POSITIONING INCREMENT | 30.0 DEGREES SINGLE ACTUATOR |
| SWITCH CONTACT BASIC DESIGN | NONPILE-UP SYMMETRICAL |
| TERMINAL TYPE | TAB, SOLDER LUG |
| TEST DATA DOCUMENT | 81349-MIL-S-3786/14 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| THREAD CLASS | 2A 1ST MOUNTING FACILITY |
| THREAD CLASS | 2B 2ND MOUNTING FACILITY |
| THREAD LENGTH | 0.375 INCHES NOMINAL SINGLE MOUNTING FACILITY |
| THREAD QUANTITY PER INCH | 32 2ND MOUNTING FACILITY |
| THREAD SERIES DESIGNATOR | UNC 2ND MOUNTING FACILITY |
| THREAD SERIES DESIGNATOR | UNEF 1ST MOUNTING FACILITY |
| THROW QUANTITY | 6 SINGLE SECTION REAR |
| UNTHREADED MOUNTING HOLE DIAMETER | 0.138 INCHES NOMINAL SINGLE MOUNTING FACILITY |