| CONTACT VOLTAGE RATING IN VOLTS | 115.0 AC AT SEA LEVEL |
| 28.0 DC AT SEA LEVEL |
| CONTACT LOAD CURRENT RATING | 250.0 MILLIAMPERES RESISTIVE LOAD AC AT SEA LEVEL |
| 500.0 MILLIAMPERES RESISTIVE LOAD AND |
| 50.0 MILLIAMPERES INDUCTIVE LOAD DC AT SEA LEVEL |
| TERMINAL TYPE | TAB, SOLDER LUG |
| SWITCH ACTUATOR INDEXING POSITION QUANTITY | 12 SINGLE ACTUATOR |
| STYLE DESIGNATOR | CIRCULAR WAFER, BUSHING MOUNT |
| OVERALL LENGTH | 4.361 INCHES NOMINAL |
| OVERALL HEIGHT | 1.531 INCHES NOMINAL |
| OVERALL WIDTH | 1.375 INCHES NOMINAL |
| INDIVIDUAL SECTION QUANTITY | 5 |
| SWITCH CONTACT BASIC DESIGN | NONPILE-UP SYMMETRICAL |
| POLE QUANTITY | 1 EACH SECTION REAR |
| THROW QUANTITY | 11 EACH SECTION REAR |
| CONTACT SWITCHING ACTION | BREAKS BEFORE MAKES 1ST SECTION REAR |
| BREAKS BEFORE MAKES 2ND SECTION REAR |
| BREAKS BEFORE MAKES 3RD SECTION REAR |
| BREAKS BEFORE MAKES 4TH SECTION REAR |
| MAKES BEFORE BREAKS 5TH SECTION REAR |
| SWITCH ACTUATOR POSITIONING INCREMENT | 30.0 DEGREES SINGLE ACTUATOR |
| SHAFT TYPE | ROUND, FLATTED SINGLE ACTUATOR |
| FIRST FLAT LENGTH | 0.438 INCHES NOMINAL SINGLE ACTUATOR |
| FLAT HEIGHT | 0.218 INCHES NOMINAL SINGLE ACTUATOR |
| SHAFT DIAMETER | 0.250 INCHES NOMINAL SINGLE ACTUATOR |
| SHAFT LENGTH | 0.938 INCHES NOMINAL SINGLE ACTUATOR |
| NONTURN DEVICE TYPE | PIN AT 8:00 O'CLOCK |
| NONTURN DEVICE RADIUS | 0.531 INCHES NOMINAL AT 8:00 O'CLOCK |
| MOUNTING METHOD | THREADED BUSHING W/PANEL SEAL SINGLE MOUNTING FACILITY |
| THREAD SERIES DESIGNATOR | UNEF SINGLE MOUNTING FACILITY |
| NOMINAL THREAD SIZE | 0.375 INCHES SINGLE MOUNTING FACILITY |
| THREAD CLASS | 2A SINGLE MOUNTING FACILITY |
| THREAD LENGTH | 0.375 INCHES NOMINAL SINGLE MOUNTING FACILITY |
| TEST DATA DOCUMENT | 81349-MIL-S-3786/2 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| SHAFT FLAT/SLOT ANGULAR LOCATION | 180.0 DEGREES FROM CONTACT POSITION 1 SINGLE ACTUATOR |
| OPERATING TEMP RANGE | -65.0 TO 85.0 DEG CELSIUS |