| DUTY TYPE | CONTINUOUS |
| ARC QUENCHING METHOD | AIR |
| CENTER TO CENTER DISTANCE BETWEEN MOUNTING FACILITIES PARALLEL TO LENGTH | 0.840 INCHES MINIMUM AND 0.860 INCHES MAXIMUM SINGLE MOUNTING FACILITY |
| COIL QUANTITY | 1 |
| CRITICALITY CODE JUSTIFICATION | FEAT |
| CUBIC MEASURE | 0.109 CUBIC INCHES |
| ENVIRONMENTAL PROTECTION | HERMETIC |
| FEATURES PROVIDED | COIL VOLTAGE SUPPRESSION AND POLARIZED |
| FRAGILITY FACTOR | MODERATELY RUGGED |
| MAIN CONTACT LOAD CURRENT RATING AT MAXIMUM RATED VOLTAGE | 125.0 MILLIAMPERES AC AND 2.0 AMPERES DC RESISTIVE LOAD |
| MAIN CONTACT LOAD CURRENT RATING AT MAXIMUM RATED VOLTAGE | 300.0 MILLIAMPERES DC INDUCTIVE LOAD |
| MAIN CONTACT MAXIMUM VOLTAGE RATING IN VOLTS | 115.0 AC AND 28.0 DC |
| MAIN CONTACT LOAD CURRENT RATING AT MAXIMUM RATED VOLTAGE | 100.0 MILLIAMPERES DC LAMP LOAD |
| OVERALL HEIGHT | 0.300 INCHES MINIMUM AND 0.320 INCHES MAXIMUM |
| OVERALL LENGTH | 1.042 INCHES MINIMUM AND 1.062 INCHES MAXIMUM |
| OVERALL WIDTH | 0.300 INCHES MINIMUM AND 0.320 INCHES MAXIMUM |
| MOUNTING FACILITY PATTERN | IN-LINE SINGLE MOUNTING FACILITY |
| MOUNTING FACILITY TYPE AND QUANTITY | 2 UNTHREADED HOLE SINGLE MOUNTING FACILITY |
| NONPILE-UP MAIN CONTACT ARRANGEMENT | 2 POLE, DOUBLE THROW, ONE POSITION MOMENTARY |
| OPERATING VOLTAGE RATING AND TYPE AT SPECIFIED TEMP | 6.0 VOLTS DC 25 DEG CELSIUS SINGLE WINDING |
| PURPOSE FOR WHICH DESIGNED | GENERAL |
| SPECIAL FEATURES | FAILURE RATE LEVEL 0.1 PERCENT |
| SPECIFICATION/STANDARD DATA | 81349-MIL-R-39016/37 GOVERNMENT SPECIFICATION |
| WINDING DC RESISTANCE RATING | 56.0 OHMS NOMINAL SINGLE WINDING |
| WINDING QUANTITY | 1 |
| STORAGE TYPE | GENERAL PURPOSE WAREHOUSE |
| TERMINAL TYPE AND QUANTITY | 8 PIN ALL FUNCTIONS |
| TEST DATA DOCUMENT | 81349-MIL-R-39016 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| TIME DELAY | 0.004 SECONDS MAXIMUM FIXED OPERATE TIME |
| TIME DELAY | 0.006 SECONDS MAXIMUM FIXED RELEASE TIME |
| UNTHREADED MOUNTING HOLE DIAMETER | 0.091 INCHES MINIMUM AND 0.101 INCHES MAXIMUM SINGLE MOUNTING FACILITY |