| ELECTRICAL ERROR ANGULAR RANGE IN MINUTES | -5.0 TO 5.0 |
| ACTUATOR FRICTION TORQUE AT PLUS 25 DEG CELSIUS | 2.00 INCH-OUNCES NOMINAL |
| ALIGNMENT HOLE BOLT CIRCLE DIAMETER | 1.1000 INCHES NOMINAL |
| ALIGNMENT HOLE DEPTH | 0.1250 INCHES MINIMUM |
| ALIGNMENT HOLE QUANTITY | 4 |
| BODY STYLE | STANDARD ROUND B |
| BODY SIZE | 15 |
| COMPENSATION METHOD | RESISTOR COMPENSATED |
| COMPENSATOR DC RESISTANCE IN OHMS | 295.00 NOMINAL |
| COMPENSATOR TRANSFORMATION RATIO IN PERCENT | 0.985 ROTOR TO COMPENSATOR NOMINAL |
| FLANGE DIAMETER | 1.4370 INCHES NOMINAL |
| FLANGE THICKNESS | 0.0830 INCHES NOMINAL |
| FRAGILITY FACTOR | MODERATELY RUGGED |
| FREQUENCY IN HERTZ | 400.0 NOMINAL |
| INTERAXIS ERROR ANGULAR RANGE IN MINUTES | -5.0 TO 5.0 |
| LENGTH | 0.1320 INCHES NOMINAL SHOULDER |
| OVERALL LENGTH | 1.4370 INCHES MAXIMUM |
| MATERIAL | ALUMINUM ALLOY OR STEEL CORROSION RESISTING BODY |
| MAXIMUM TOTAL NULL VOLTAGE OUTPUT IN MILLIVOLTS PER VOLT | 150.00 |
| MOUNTING SURFACE TO TERMINAL END DISTANCE | 2.0630 INCHES MAXIMUM |
| OUTPUT VOLTAGE FUNCTIONAL ERROR RANGE IN PERCENT | -0.1 TO 0.1 |
| PILOT LENGTH | 0.0400 INCHES NOMINAL |
| PHASE SHIFT ANGLE IN DEG | 6.000 INPUT TO OUTPUT NOMINAL |
| PILOT DIAMETER | 0.8750 INCHES MAXIMUM |
| ROTOR DC RESISTANCE IN OHMS | 200.00 NOMINAL |
| SCHEMATIC DIAGRAM DESIGNATOR | 2 ROTOR, 2 STATOR, 2 COMPENSATOR, 2 RESISTOR |
| SHAFT DIAMETER | 0.1873 INCHES NOMINAL SINGLE SHAFT |
| SHAFT LENGTH | 0.5310 INCHES NOMINAL SINGLE SHAFT |
| SHAFT MAXIMUM RADIAL PLAY | 0.0005 INCHES |
| SHAFT MAXIMUM RUNOUT | 0.0005 INCHES |
| SHAFT TYPE | ROUND SINGLE SHAFT |
| SHOULDER DIAMETER | 1.3120 INCHES MAXIMUM |
| STATOR INPUT VOLTAGE RATING IN VOLTS | 30.0 NOMINAL |
| STATOR DC RESISTANCE IN OHMS | 295.00 NOMINAL |
| STATOR INPUT CURRENT RATING | 45.0 MILLIAMPERES MAXIMUM |
| TERMINAL DESIGNATOR AND SCHEMATIC POSITION | CONNECTION R1 POSITION J AND CONNECTION R2 POSITION G AND CONNECTION R3 POSITION E AND CONNECTION R4 POSITION J AND CONNECTION S1 POSITION B AND CONNECTION S2 POSITION C AND CONNECTION S3 POSITION A AND CONNECTION S4 POSITION D AND CONNECTION C1 POSITION L AND CONNECTION C2 POSITION M AND CONNECTION C3 POSITION K AND CONNECTION C4 POSITION N |
| TERMINAL LOCATION | REAR |
| TERMINAL TYPE AND QUANTITY | 12 SCREW |
| TRANSFORMATION RATIO EQUALITY IN PERCENT | 0.1 NOMINAL |
| TRANSFORMATION RATIO | 0.980 ROTOR TO STATOR NOMINAL |
| UNDERCUT WIDTH | 0.0780 INCHES NOMINAL |